Sapphire Audio DV425TR owner manual Maintenance, Glass Cleaning, Gold - Care And Treatment

DV425TR DIRECT VENT ROOM HEATER

MAINTENANCE

Installation and repair should be done only by a qualified service person. The appliance should be inspected before use and at least annually by a professional service person. More frequent cleaning may be required due to excessive lint from carpeting, bedding material, pet hair, et cetera. It is imperative that control compartments, burners and circulating air passageways of the appliance be kept clean. Note: If venting is disconnected for any reason, the vent-air intake system must be properly resealed and reinstalled.

GLASS CLEANING

WARNING! DO NOT CLEAN GLASS WHEN HOT! TURN UNIT OFF AND ALLOW TO COOL. DO NOT USE ABRASIVE or CHEMICAL CLEANERS ON GLASS SURFACE! DO NOT OPERATE WITH THE GLASS FRONT REMOVED CRACKED OR BROKEN! DO NOT STRIKE OR SLAM THE DOOR!

___Turn off pilot light.

___Open door by releasing two spring latches at the top of appliance door beneath the top, and lift door up.

___Using glass cleaner, wipe with soft cloth or clean paper towel until surface is dry.

___Relight pilot.

___Re-attach door.

___Check burner operation.

NOTE: If you observe a white film on the door glass, use a hard water deposit glass cleaner or contact your dealer. The use of a glass cleaner will reduce the mineral deposits.

GOLD - CARE AND TREATMENT

WARNING! You must clean all the fingerprints and oils from gold surfaces prior to firing the stove for the first time. Use a glass cleaner or vinegar and a very soft towel to remove the oils. If gold is not cleaned properly prior to lighting the first fire, the oils remaining from fingerprints can cause permanent staining on the gold plating. After the plating is cured, the oils will not affect the finish and regular maintenance can be provided using glass cleaner and a very soft cloth as needed.

02/01 Page 51 250-5533