Sapphire Audio DV425TR owner manual Rear Vent Conversion Instructions

DV425TR DIRECT VENT ROOM HEATER

REAR VENT CONVERSION INSTRUCTIONS

(See Parts & Accessories, page 57 for part number.)

KIT CONTENTS: Rear vent grill; .096 NG orifice;

.059 LP orifice; Rear Vent Cover Plate, Top Grill Cover Plate

TOOLS REQUIRED: Power drill; #2 Phillips bit; 5/32" Allen wrench; 5/8" open end wrench; high-temp sili- cone sealant (optional.)

STEP A: Convert to Rear Vent:

A-1 - At the REAR of stove:

1.Remove rear access plate on back shield and discard. See Fig. 1

2.Remove rear outer flue cover plate, (with damper adjustment plate attached), ensure that gaskets and grommet stay in place.

3.Remove inner flue cover plate; set aside.

A-2 - At the TOP of stove, with exceptions noted:

4.Lift out cast insert piece on top.

5.Remove outer flue collar and set aside. See Fig. 3 Ensure that gasket is intact, if not, high temperature silicone can be used as an alterna- tive to gasket replacement in step 12 below.

6.Lift out inner flue collar with damper in place. See Fig. 4

FIG. 2

Rear Inner Flue Plate

FIG. 3

FIG. 1

Damper

Adj. Plate

Rear Access Plate

Rear Outer

Flue Cover

FIG. 4

02/01 Page 10 250-5533