Sapphire Audio DV425TR owner manual LP CONVERSION, CONT Valve Regulator Replacement

DV425TR DIRECT VENT ROOM HEATER

LP CONVERSION, CONT.

Valve Regulator Replacement

1.Turn control knob to the OFF position, ensure that gas supply to the valve has been turned off.

2.Using a Torx TH20, or slotted screwdriver, remove the three pressure regulator mounting screws (A), pressure regulator tower (B), and diaphragm (C). (You may wish to retain these items for converting back to original gas if necessary.)

3.Ensure that the rubber gasket (D) is properly positioned and install the new HI/LO pressure regulator assembly to the valve using the new screws (E) supplied with the kit. Tighten screws securely. (Reference torque = 25 in/lb)

4.Install the enclosed identification label (F) to the valve body where it can be seen.

5.Re-install burner plate: First slide burner tube into shut- ter and over holes. Secure plate with screws.

6.Re-install log/burner pan. Slide vertically into the back of firebox and then place horizontal onto burner plate. Refer to Fig. 1 again.

7.Install logs, refer to Owner's Manual for correct place- ment.

8.Replace glass door and front.

A

B

C

E

D

F

02/01 Page 14 250-5533