DV425TR DIRECT VENT ROOM HEATER
HEARTH LEGS INSTALLATION
BLOWER INSTALLATION, cont.
NOTE: HEARTH LEGS CAN NOT BE USED IF A
BLOWER IS INSTALLED AS THERE WILL NOT BE ENOUGH CLEARANCE.
Refer to page 56, Parts & Accessories for specific color part numbers.
Hearth legs will allow three additional inches of clearance. Be sure to calculate this distance correctly if necessary to cut wall hole to install horizontally. Refer to Dimensions on page 7.
To change legs, use a 1/2" wrench to remove and replace one leg at a time while the unit is in an upright position.
BLOWER INSTALLATION
PART
KIT CONTENTS: Blower motor; snapdisc bracket with wire harness; rheostat, rheostat nut; knob; screws; 1
TOOLS REQUIRED: #2 Phillips head bit; hand drill; 11/16's wrench.
1.Mount blower to rear of unit using two screws. See Fig. 1
2.Beneath the stove from its front side, ensure that all wiring is moved behind the blower mounting bracket, and complete blower mounting by inserting two screws. See Fig. 2
3.Make the wire harness connection. Fig. 2
4.Use 2 screws to connect the snapdisc bracket to blower mounting bracket. Fig. 3
5.Route wires from snapdisc to the right, upper edge of blower. Fig. 3
6.Insert rheostat control into it's opening from beneath the control panel. Fit the rheostat nut on top and tighten the nut using an 11/16" wrench. Attach black knob. Fig. 4
7.Gather any excess in the wiring and
Note: This blower utilizes a snapdisc to control ON and OFF operation. When the correct temperature is reached, the blower will automatically turn ON. Use the rheostat knob to adjust the fan to High or Low to suit your preferences.
FIG. 1
FIG. 2
Blower mounting bracket beneath stove as seen from front.
FIG. 4
Wire Harness
Connector
Blower from front view beneath stove.
FIG. 3
Snapdisc Bracket
Blower rheostat control
Ensure these wires are
BEHIND the mounting bracket.
02/01 | Page 16 |