DV425TR DIRECT VENT ROOM HEATER
GENERAL VENTING INSTRUCTIONS
PLEASE NOTE: In order to comply with applicable codes and product warranties, only Simpson Dura- Vent venting components may be used. DO NOT USE
This appliance is a direct vent heater. All combustion air must come directly from the outside of the building. The vent pipe for this unit consists of an inner and an outer pipe. The inner pipe carries the stove exhaust out of the system, and the outer pipe brings fresh combustion air into the stove.
!A wall thimble is optional when the venting passes through a wall.
!A support box or firestop is required when the venting passes through a ceiling.
Roof flashing and a storm collar are required when venting passes through the roof. Follow instructions provided with the venting for installation of these items.
IMPORTANT: Read all these instructions carefully before starting the installation. Failure to follow instructions may create a fire or other safety hazard, and will void the warranty. Be sure to follow these installation instructions for venting and clearance to combustible requirements, which may vary from one installation to another. Do not extend the venting system in excess of the distance prescribed in these manufacturer’s installation instructions. This gas appliance must not be connected to a chimney flue serving a separate
The Dovre DV425TR is an engineered product that has been designed and tested. The warranty will be voided, and serious fire, health, or other safety hazards may result from any of the following actions: Installation of any damaged venting component, unauthorized modification of the venting system, installation of any component part not approved by Aladdin Hearth Products, or installation other than as instructed by these instructions. Consult your local building codes before beginning this installation.
WARNING: Always maintain the required clearances (air space) to nearby combustibles to avoid creating a fire hazard. Do not fill air space with insulation. Minimum clearance between vent pipes and combustible surfaces is 1” (25mm). Be sure to check the horizontal vent termination clearance requirements from decks, windows, soffits, gas regulators, air supply inlets and public walkways, as specified on pages
The gas heater and vent system must be vented directly to the outside of the building, and never be attached to a chimney serving a separate solid fuel or
INSTALLATION PRECAUTIONS:
02/01 | Page 18 |