Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
TROUBLESHOOTING & REPAIR
ENGINE/STATOR/ROTOR REMOVAL AND REPLACEMENT (continued)
FIGURE F. 27 – ENGINE STARTER SOLENOID LEADS (ONAN ENGINE SHOWN)
STARTER
PLASTIC
COVER ON
SOLENOID
10.Refer to Figure F.27. Label engine starter solenoid leads #211A and #209 (#211A attaches to the solenoid spade terminal and #209 attaches to the positive stud on the solenoid along with the positive battery cable). Pull lead #211A off its spade terminal. To remove lead #209, you will have to remove the plastic cover on the starter first. To do this, use the 1/2" socket wrench to remove the nut on the negative stud of the solenoid. Then remove the plastic cover. Next, remove the 1/2" nut from the positive solenoid stud. Now you can remove lead #209 and the positive battery cable from the starter solenoid.
