Section TOC
Master TOC
TROUBLESHOOTING & REPAIR
ENGINE/STATOR/ROTOR REMOVAL AND REPLACEMENT (continued)
FIGURE F.30 – STATOR AND ROTOR REMOVAL
Return to
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to
Return to Master TOC
Return to Master TOC
Return to Master TOC
1.STATOR
2.BRUSH HOLDER ASSEMBLY
3.ROTOR
4.BLOWER FAN
5.TOLERANCE RING
6.ROTOR BEARING
7.IDLER SOLENOID
8.ROTOR
9.LIFTING EYE
2
1
5
3
4
Stator/Rotor Assembly Removal
Refer to Figure F.30.
1.Support the stator with the hoist.
2.Using the 1/2" wrench, remove the bolt, washers, and nut holding the muffler to the stator (Onan engine machines). Remove the bolts and washers holding the muffler to the engine and remove the muffler.
3.Disconnect the idler solenoid linkage at its clip.
9
8
6
7
4.Using the 7/16" wrench, remove the two nuts, lock washers, and bolts holding the brush holder assembly to the stator frame. Remove the brush holder assembly.
5.Unscrew the fan to remove it from the shaft. Turn the fan counterclockwise. Be careful not to lose the washer that fits between the blow- er fan and the rotor.
