Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
|
| ||
TROUBLESHOOTING & REPAIR |
| ||
Observe Safety Guidelines |
| TROUBLESHOOTING GUIDE | |
detailed in the beginning of this manual. |
|
| |
|
|
| |
PROBLEMS | POSSIBLE AREAS OF | RECOMMENDED | |
(SYMPTOMS) | MISADJUSTMENT(S) | COURSE OF ACTION | |
|
|
|
|
| FUNCTION PROBLEMS |
|
|
The wire feeder does not work | 1. Check the appropriate circuit | 1. Check for the presence of | |
when connected to the welder | breaker (CB1 or CB8). Reset if | appropriate | source voltage at |
amphenol. | tripped. | the | |
| 2. The wire feeder control cable | 2. If the appropriate voltage (42 | |
| may be faulty. | VAC or 115 VAC) is NOT pre- | |
| 3. The wire feeder may be faulty. | sent at the | |
| check for loose or faulty con- | ||
|
| ||
|
| nections. | See the Wiring |
|
| Diagram. |
|
|
| 3. Perform the Stator Voltage | |
|
| Test. |
|
|
|
| |
The battery does not stay charged. | 1. Check for loose or faulty con- | 1. If the yellow engine alternator | |
| nections at the battery and | light is on, perform the | |
| engine charging system. | Flywheel Alternator Test. | |
| 2. The battery may be faulty. | 2. If the battery is not charging and | |
| Check or replace. | the yellow | engine alternator |
|
| light is not lit. The battery board | |
|
| may be faulty. | |
|
|
|
|
CAUTION
If for any reason you do not understand the test procedures or are unable to perform the test/repairs safely, contact the Lincoln Electric Service Department for electrical troubleshooting assistance before you proceed. Call
