Lincoln Electric SVM150-A service manual Accessories

C-7 C-7

ACCESSORIES

Return to Section TOC

Return to Section TOC

Return to Master TOC

Return to Master TOC

CONNECTION OF THE LN-7 TO THE RANGER 250 USING K584 CONTROL CABLE (SEE FIGURE C.5.)

NOTE: If your LN-7 comes equipped with a K291 or K404 input cable, refer to CONNECTION OF THE LN- 7 Using K867 UNIVERSAL ADAPTER, rather than this discussion, to connect your Ranger 250 for wire feed welding.

1.Shut the welder off.

2.Connect the electrode cable from the K584-XX Control Cable to the “+” terminal of the welder and to the LN-7 wire feeder. Connect the work cable to the “-” terminal of the welder.

NOTE: Figure C.5 shows the electrode connected for positive polarity. To change polarity, shut the welder off and reverse the electrode and work cables at the out- put terminals.

NOTE: Welding cable must be sized for current and duty cycle of application.

3.Connect the input cable from the K584-XX Control Cable to the 14-pin amphenol on the Ranger 250 and the input cable plug on the LN-7.

4.Set the “VOLTMETER” switch to “+” or “-” depend- ing on the polarity chosen.

5.Set the “MODE” switch to the “CV-WIRE” position.

6.Place the “IDLER” switch in the “HIGH” position.

CAUTION

Any increase of the high idle engine RPM by changing the governor setting or overriding the throttle linkage will cause an increase in the AC auxiliary voltage. If this voltage goes over 140 volts, wire feeder control cir- cuits may be damaged. The engine governor setting is preset at the factory – do not adjust above RPM spec- ifications listed in this manual.

7.Place the “WELD TERMINALS” switch in the “REMOTELY CONTROLLED” position.

8.Adjust wire feed speed at the LN-7 and adjust the welding voltage with the optional remote control if used.

9.Set the “ARC” control at “0” initially and adjust to suit.

Return to Section TOC

Return to Section TOC

Return to Master TOC

Return to Master TOC

FIGURE C.5 – RANGER 250/LN-7 WITH 584 CONTROL CABLE CONNECTION DIAGRAM

-

-

RANGER 250