Powermatic 64A, 1791228K operating instructions Maintenance, Optional Accessories

Maintenance

Before doing maintenance on the machine, disconnect it from the electrical supply by pulling out the plug or switching off the main switch! Failure to comply may cause serious injury.

Good saw operation requires periodic preventive maintenance.

1.Keep the inside of the cabinet and trunnion areas clean. A stiff brush will remove sawdust before it cakes, and pitch or gum is easily removed with a commercial solvent.

2.After cleaning the tilting and raising worm, and worm gear segments, and the

trunnions, grease these three areas with a good grade non-hardening grease.

3.The table surface must be kept clean and free of rust for best results. An occasional coat of paste wax on the table will allow the wood stock to glide smoothly across the work surface.

An alternative is white talcum powder applied with a blackboard eraser rubbed in vigorously once a week to fill casting pores and form a moisture barrier. This method provides a table top that is slick and allows rust rings to be easily wiped from the surface. It is also important to note that talcum powder will not stain wood or mar finishes as wax pickup can.

Optional Accessories

708295	Tenoning Jig
709380	Zero Clearance Insert
708818	Push Stick
709721	Featherboard
2042367	Mobile base for Model 64A with 50” Rip Capacity, Ext. Table and Legs
2042370	Mobile base for Model 64A with 30” Rip Capacity, Ext. Table and Legs

2195076K Accu-Fence system, 30”

2195077K Accu-Fence system, 50"

6290550	Miter Gauge
6290694	Table insert.
6290695	Dado insert.
6441000Z	Legs, set of two.
6682004	Rout-R-Lift.
6827029	Model 64A	27" x	35-5/8" Extension Table
6827033	Model 64A	27" x	35-5/8" Extension Table for Rout-R-Lift
6827034	Model 64A	27" x	17” Extension Table for Rout-R-Lift
6827036	Model 64A	27" x	17” Extension Table

26