Powermatic 64A, 1791228K Installing Dust Shroud, Installing Switch, Miter Gauge Assembly

Installing Dust Shroud

TIP: Since the dust shroud is installed from beneath, aid from a helper to install the screws and tabs will make this task much easier.

1.From under the saw, position the dust shroud at an angle to go through the opening between the stand and the saw. Set the lip of the shroud to sit on the top side of the stand as shown in Figure 24.

2.Attach two 3/16-24 x 5/8 pan head screws and two 3/16 star washers to the tabs, and reaching in from the motor side of the saw, push the screws through the holes provided in the stand.

3.Attach two 3/16 nuts from the bottom side, and with both tabs positioned over the lip of the shroud, tighten down both screws.

Installing Switch

NOTE: The switch can not be mounted until the fence and rails are mounted. Attach the switch under the first screw from the left on the front rail. See Figure 25. The switch mounting bracket has a slot for adjustment.

The table saw is equipped with a push-button switch with safety device, shown in Figure 25. When the safety key is inserted into the start button, the button cannot be pushed in, thus preventing accidental starting of the saw. It is recommended that the safety key be placed on the machine whenever the machine is not in use.

Miter Gauge Assembly

1.Mount the gauge body to the bar, making sure the pins underneath the body insert into the holes in the bar. See Figure 26.

2.Place the fiber washer on to the threaded part of the handle, and screw on the handle.

3.Slide the miter gauge into the left hand slot on the saw table.

Motor Disconnect Plug

The motor is supplied with a special disconnecting plug to facilitate motor removal for saw transportation convenience. Before connecting or disconnecting this special plug, always make sure that the saw's main cord is unplugged.

Figure 24

Figure 25

Figure 26

16