6.Install the motor assembly onto the protruding studs at the back of the saw. See Figure 15.
7.Tighten down setscrews in top of cast motor bracket with hex wrench as shown in Figure 15.
8.Use an assistant or get a support block (for example, a 2x4) approximately 21" to 22" long. Lift motor up and position block under the motor to support its weight.
9.Slightly loosen motor base screws.
10.Confirm belt alignment using a straight edge as shown in Figure 16. NOTE: If belt needs aligning, loosen the set screws on a pulley and slide the pulley forward or backward on the shaft as needed.
11.Mount the drive belt to the pulleys by raising motor off the support block. With the drive belt mounted, lower the motor back to rest on the support block.
12.Position pulley cover seat in line with pulleys, but not so it will interfere with belt operation.
13.Adjust the motor all the way back on the slots of the base, then move it all the way to the right. See Figure 17. This will prevent the motor from rising above the table when tilted at 45 degrees. Tighten down the motor base screws.
14.Remove wing nuts with washers and install pulley cover, as shown in Figure 17, over the spacer and carriage bolt. Install the wing nut and washers and tighten down the pulley cover so that it fits snugly over the pulley cover seat.
15.Remove support block. Test for unhindered operation of the belt by turning the components by hand. Adjust as necessary.
See pages 7 and 8 for information on connecting your tablesaw to power, and voltage conversion.
Figure 17
Figure 14
Figure 15
Figure 16
13
