Powermatic 1791228K, 64A operating instructions Mounting Saw to Stand

2.Attach the four short braces to one set of legs as shown in Figure 6.

3.Complete the stand assembly by attaching the other set of legs as shown in Figure 7.

4.To attach rubber feet to each leg, first use a cross-point screwdriver and screw the 1/4- 20 x 1 pan head screw through the recessed hole of the rubber grommet as shown in Figure 8. Push the screw through the hole provided at the bottom of each leg, and tightly fasten down with 1/4 flat washer and 1/4 hex nut.

5.Remember, leave all other stand assembly nuts only finger tight!

Mounting Saw to Stand

Tip: Remove all contents from carton except saw and one extension wing. Put some soft padding on floor beside box. Fold back carton flaps and gently roll carton upside down on to padding. Lift off carton, being careful not to let extension wing fall.

1.Place table top upside down with its surface on a flat floor, and place stand, with legs upside down, atop the cabinet. See Figure 9

2.Align the holes of stand with holes on bottom flange of saw base and tightly secure with four 5/16-18 x 1 hex head screws, four 5/16 hex nuts, four 5/16 flat washers, and four 5/16 spring washers. The screw heads should be inside of the saw body (see inset, Figure 9).

3.Carefully raise the machine to its upright position.

4.With the saw located at the place of operation, (with a solid foundation), spread the stand legs to self-align the machine. (If using an optional mobile base, place the machine onto the base now). When all four legs are seated solidly on the floor (or mobile base), tighten down securely all nuts and screws in the stand assembly.

NOTE: If the saw is to be used without the metal stand provided, care must be taken to provide a hole in the stand or bench used by the operator to facilitate the removal of sawdust.

If there is any tendency to slide, walk, or tip over during operation, the stand or bench MUST be secured to the floor.

Figure 7

Figure 8

Figure 9

11