TEST INSTALLED FITTING
With HANDLES (1) in OFF position, turn on WATER SUPPLIES (2) and check all connections for 
leaks.
Operate both handles to flush water lines thoroughly.
Turn diverter to rim wash and bidet spray.
Operate Lift Rod (3) and fill Bidet with water. Check that DRAIN STOPPER (4) makes a good seal and retains water in Bidet. Adjust stopper height by repositioning Lift Rod (3) with EXTENSION ROD (6) and tightening Thumbscrew (5).
Release DRAIN STOPPER (4) and check all drain connections for 
leaks. Tighten if necessary.
2
4
3
3
5
6
2
SERVICE
To change direction of handle rotation, proceed as follows:
Turn valve to OFF position.
Remove HANDLE and ADAPTER if present.
Remove SPRING CLIP (1).
Lift STOP WASHER (2), turn 90p and replace.
Replace SPRING CLIP (1).
Replace HANDLE ASSEMBLY.
SPRAY (3) may accumulate dirt causing distorted and reduced water flow. Unscrew and remove SPRAY (3) and rinse clean.
Replace SPRAY (3) and operate handles several times from OFF to ON position. Do not force, handles turn only 90˚.
90p
2
1
3
EverClean™ Finish Care Instructions
American Standard’s EverClean finish will wipe clean with a soft, dry cloth. A soft cloth with clean water may also be used, if desired. No additional cleaning products are required.
DO NOT USE: Soaps, acid, polish, abrasives, harsh cleaners, or a cloth with a coarse surface.
. 3 & 7
