Appendix “F”
Hopper Clean-Out Drop Chute
You would have found this along with your Owner’s Manual, video and inspection card. This can have two purposes. The main one is to be an attachment to the side of the hopper to help with cleaning out the hopper. The second purpose would be used as a dust pan for your shop.
Keep this separate till needed.
Purpose:
Should you find in necessary to remove the pellets from your hopper, for any reason, this handy attachment will save time and a lot of effort.
Tools Needed:
¼” Hex Nut setter & Driver or Flat Head Screwdriver Pail or bin
6 5 4
Access
Panel
3 | 2 | 1 |
| B | A |
How to Install:
1.Unplug the appliance power cord from the wall outlet.
2.To gain access to the inside of the appliance, remove the ¼” hex screws from the LEFT HAND SIDE PANEL (looking from the front of the heater). These are located on the back left hand side corner of the appliance.
3.Remove the panel simply by sliding it back toward the exhaust.
4.Remove the 2 – ¼” hex screws, labeled A & B.
5.Install the Hopper Drop Chute,
6.Remove the 5 - ¼” hex screws from the side hopper access panel. Number 1 – 5 (see picture)
7.Loosen the #6 screw, but leave it attached. This now allows the access panel to act as a door.
8.Place a catch pail under the drop chute.
9.Raise and lower the access panel as needed.
10.When finished cleaning out as many pellets as possible,
Copyright 2004 | 38 | Cheap Charlie Owner’s Manual |
Canadian Comfort Industries | www.dansons.com | Dansons Group Inc. |
