SPECIFICATIONS
HEATING SPECIFICATIONS
- Approx. Heating capacity (Sq Feet) ¹ | = 800 – 2,000 sq ft |
- Approx. Fuel burn rate per hour ¹¹ | = 1.75 – 5.5 lbs per hour |
- Hopper Capacity CC Edison Jr. / CC Franklin120 | = 120+ pounds |
- Hopper Capacity CC Edison Sr./ CC Franklin300 | = 300+ pounds |
¹ Heating capacity will vary depending on floor plan layout of your home, degree of insulation, and the outside temperature. Fuel size, quality, density and moisture level will also have an effect.
¹¹Pellet size may affect the actual rate of fuel feed and burn times. Fuel feed rates may vary by as much as 20%. Use PFI listed fuel for best results.
DIMENSIONS
| 24” |
|
|
|
|
| 26” |
| CC EDISON Sr./ | Weight |
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
| 272 lbs. | |
|
| |||||||||
|
|
|
|
|
|
|
|
| CC FRANKLIN 300 | |
|
|
|
|
|
|
|
|
| CC EDISON Jr. / |
|
|
|
|
|
|
|
|
|
| CC FRANKLIN 120 | 225 lbs. |
| 46 1/2” |
|
|
|
| 8 1/4” |
|
|
| Exhaust | |
|
| + |
|
|
| + | 8 3/4” |
| 3 3/4” |
|
|
| Air Inlet | 14 1/4” |
|
CC EDISON Sr./ | Common for |
| |
|
| ||
CC FRANKLIN 300 |
| all models |
|
24”
31 1/2”
CCEDISON Jr. / CC FRANKLIN 120
ELECTRICAL SPECIFICATIONS
Electrical Rating | = | 115 | Volts 60 HZ 2.0 Amps |
Watts (operational) | = | 175 | (approximately) |
Watts (optional igniter) | = | 475 | (approximately) |
A voltage surge protector or ground fault outlet is required for this unit. The warranty on the circuit board will be voided if surge protection is not installed before operating this unit.
FUEL CONSIDERATIONS
Your Cheap Charlie shop and home heater, is designed to burn pellets that comply with Association of Pellet Fuel Industries standards. (Minimum of 40lbs density per cubic ft, ¼ to 5/16’ diameter length no greater than 1.5”, not less than 8,200 BTU’s/lb, moisture under 8% by weight, ash under 1% by weight, and salt under 300 parts per million) Pellets that are soft, contain excessive amounts of loose sawdust, have been or are wet, produce clinkers and/or heavy ash will result in reduced performance and may actually cause the fire to go out.
(see pelletheat.org for further information)
EPA COMPLIANCE
This heater is exempt from EPA Phase II requirements, but has been tested for emissions using EPA test methods by Warnock Hersey , US. Pellet appliances that are designed with the combustion air supply exceeding 35:1 (by ratio) are exempt from EPA regulations.
PRODUCT IS SUBJECT TO CHANGE WITHOUT NOTICE.
Copyright 2004 | 6 | Cheap Charlie Owner’s Manual |
Canadian Comfort Industries | www.dansons.com | Dansons Group Inc. |
