Zanussi ZFC 282 C manual Installation, Location, Rear spacers, Power connection

INSTALLATION

If this refrigerator featuring magnetic door seals is to replace an older appliance having a spring lock on the door or lid, be sure to make that spring lock unusable before you discard the old appliance.

This will prevent it from becoming a death-trap for a child.

Location

The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc.

Best performance is obtained with ambient temperature between +18°C and +43°C (class T); +18°C and +38°C (class ST); +16°C and +32°C (class N); +10°C and +32°C (class SN).

The class of your appliance is shown on its rating plate.

Make sure that there is nothing hindering air circulation at the back, bottom, or top of the appliance.

To achieve the best performance when the appliance is set under a wall cabinet the top of the appliance should be at least 5 mm away from the base of the cabinet (Fig. 1/A).

However, the appliance should ideally not be installed underneath wall cabinets (as shown in Fig. 1/B).

One or more adjustable feet mounted on the base of the appliance make it possible to set it perfectly level.

	Fig. 1
min.
50 cm2
A	B
min.	min.
50 cm2	50 cm2
D584

Rear spacers

In the bag with the documentation, there are two spacers which must be fitted as shown in the figure 2.

Slacken the screws and insert the spacer under the screw head, then re-tighten the screws.

Fig. 2

PR153

Power connection

Before plugging in, ensure that the voltage and frequency shown on the serial number plate correspond to your domestic power supply. Voltage can vary by ±6% of the rated voltage. For operation with different voltages, a suitably sized auto-transformer must be used.

The appliance must be earthed.

The power supply cable plug is provided with a contact for this purpose.

If the domestic power supply socket is not earthed, connect the appliance to a separate earth in compliance with current regulations, consulting a specialist technician.

The Manufacturer declines all responsibility if the above safety precautions are not observed.

This appliance complies with EEC directive number 87/308 of 2/6/87 relative to radio interference suppression.

This appliance complies with the following E.E.C. Directives:

-73/23 EEC of 19.2.73 (Low Voltage Directive) and subsequent modifications;

-89/336 EEC of 3.5.89 (Electromagnetic Compatibility Directive) and subsequent modifications.

Cleaning the appliance’s interior

Before using the appliance for the first time, wash all internal parts with lukewarm water and neutral soap so as to remove the typical «new» smell and then drv thoroughly.

Do not use detergents or abrasive powders as these will damage the finish.

12