Fitting the Hob into the
Worktop
Carry out the building in of the hob as follows:
1.place the seals supplied with the hob on the side edges of the cut out and at 8 mm. from the front and rear edges, as shown in the diagram, taking care that the seals meet without overlapping;
2.place the hob in the cut out, taking care that it is centred;
3.fix the hob with the relevant fixing clamps and screws, as shown in the diagram. When the screws have been tightened, the excess seal can be removed.
The edge of the hob forms a double seal which prevents the ingress of liquids.
Seal
19