INSTALLING THE COOKER HOOD
Drilling the Ceiling/Support
Shelf
•Use a plumb line to mark the centre of the hob on the ceiling/support shelf.
•Place the drilling template 21 provided on the ceiling/ support shelf, making sure that the template is in the correct position by lining up the axes of the template with those of the hob.
•Mark the centres of the holes in the template.
•Drill the holes at the points marked:
•For concrete ceilings, drill for plugs appropriate to the screw size.
•For hollow brick ceilings with wall thickness of 20
mm:drill ø 10 mm (immediately insert the Dowels not provided).
•For wooden beam ceilings, drill according to the wood screws used.
•For wooden shelf, drill ø 7 mm.
•For the power supply cable feed, drill ø 10 mm.
•For the air outlet (Ducted Version), drill according to the diameter of the external air exhaust duct connection.
•Insert two screws of the following type, crossing them and leaving
•For concrete ceilings, use the appropriate plugs for the screw size (not provided).
•For Cavity ceiling with inner space, with wall thi- ckness of approx. 20 mm, Screws not provided.
•For wooden beam ceilings, use 4 wood screws (not provided).
•For wooden shelf, use 4 screws with washers and nuts (not provided)
Fixing the Frame
•Unfasten the two screws fastening the upper chimney stack 2.1 to the frame, and remove the chimney from the upper stack.
If you wish to adjust the height of the frame, proceed as follows:
•Unfasten the four safety screws located at the top in the frame separation area. (A)
•Unfasten the eight metric screws joining the two columns, located at the sides of the frame. (B)
•Adjust the frame to the height required, then replace all the screws removed as above.
•To guarantee greater stability in the frame, replace the four safety screws in the last hole available.
•Insert the upper chimney stack from above, and leave it running free on the frame.
A
B
14
