INSTALLING THE COOKER HOOD
•Lift the frame up, making sure that the index over the frame plate is turned backwards.
•Fit the frame slots onto the two screws inserted in the ceiling as above, and turn until reaching the centre of the adjustment slot.
•Tighten the two screws and fasten the other two screws provided; before locking the screws comple- tely, it is possible to adjust the frame by turning it, making sure that the screws do not come out of their housing in the adjustment slot.
•The Frame must be securely fastened so as to support both the weight of the Hood and the stress caused by occasional axial pressure against the fitted Appliance. After fixing, make sure that the base is stable even when the Frame is subjected to lateral stress.
•If the Ceiling is not strong enough in the area where the hood is to be fixed, the Installer must strengthen the area using suitable plates and counterplates anchored to resistant structures.
Extraction
The cooker hood is more effective when used in the extraction mode (ducted to the outside).
Venting kits may be purchased through your retailer or DIY store, and must be ducted to an outside vent of Ø125mm (5”) or Ø150mm (6”).
For the best performance use the shortest possible duct run and the minimum number of bends.
Where flexible ducting is fitted it should not be turned through very tight bends as this may impair the perform- ance of the hood.
It is recommended a maximum length of 3 metres with one bend, to be installed, to be reduced metre for each 90o bend.
If a distance is greater than 3 metres the efficiency of the hood could be impaired.
The ducting used must be manufactured from fire retardent material conforming to the relevant British Standard or DIN
When the cooker hood is ducted to the outside the charcoal filter must be removed.
2
1
1 
2
15
