Zanussi ZHC 935 7.2.1, X 1-2 mm, 965 min, Fitting the Wall Brackets, Installing The Cooker Hood

INSTALLING THE COOKER HOOD

7.2.1

X 1-2 mm

116	116
965 min.	965

Fitting the Wall Brackets

Draw a vertical line on the wall from the centre of the cooking appliance up to the ceiling, or as high as the adjoing wall cabinets using a spirit level and marker pen. This is to ensure the correct vertical alignment of the appliance.

-Draw a horizontal line 965mm above the hob

-Mark a hole centre on the horizontal line 965mm above the worktop, 116mm either side of the vertical line as indicated.

-Drill the holes marked on the wall using a Ø8mm drill-bit.

-Fix the two brackets item 7.2.1.

-Place bracket item 7.2.1 on the wall as shown about 1-2mm from the ceiling or upper limit aligning-notch in the centre of the bracket with the vertical line.

Mark the hole centres for the bracket fixing screws on the wall.

-Place bracket item 7.2.1 on the wall as shown at 215mm below the first bracket at X.

-Mark the hole centres for the bracket fixing screws on the wall.

13