INSTALLATION INSTRUCTIONS
FITTING INTO THE SPACE BETWEEN CABINETS
IMPORTANT: Ensure that the oven is switched off at the wall before any further work is carried out.
Ensure the appliance is in front of the cabinet. See Fig. 13.
Take out all oven furniture before installation to reduce the weight you need to lift.
To place the appliance into the space between cabinetry follow the procedure below:
N.B. Two people will be required to carry out the lifting procedure.
Warning: Do not attempt to lift this appliance by the handle(s).
Each person should squat either side of the appliance.
Tilt the appliance so that your hands can support the underside of the appliance.
Raise the appliance to the correct height.
Rest the rear underside of the appliance on the mounting brackets while your hands support the front.
The appliance can be pushed fully into the space. Take care to avoid fouling the mains lead.
Ensure the appliance is central and level.
When the appliance is fully housed, screw the stability screws (supplied with the appliance) into the underside of the worksurface in the positions indicated (see Fig. 14), taking care not to distort the trim. It is advisable to turn each screw alternatively to avoid damaging the trim.
Place the top trim flush with the edge of the worksurface, with the cork spacers upover (see Fig.15) and screw into position using the screws supplied with the appliance.
Replace the plinth board.
Switch on the appliance and refer the user to the operating instructions.
Fig.13
Fig.14
Fig.15
42
