INSTALLATION
If this refrigerator featuring magnetic door seals is to replace an older appliance having a spring lock on the door or lid, be sure to make that spring lock unusable before you discard the old appliance.
This will prevent it from becoming a
Location
The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc. Best performance is obtained with ambient temperature between +18°C and +43°C (class T); +18°C and +38°C (class ST); +16°C and +32°C (class N); +10°C and +32°C (class SN). The class of your appliance is shown on its rating plate.
Power connection
Before plugging the appliance into the mains socket, check that the voltage and frequency indicated on the appliance’s rating plate are the same as those provided by your home power supply. A 6% fluctuation above or below rated voltage is acceptable.
For operation using different voltages you should use an autotransformer of suitable capacity.
The appliance’s plug and the wall socket are fully compatible, without any need to use adaptors, multiple plugs, etc. If this is not the case, the wall socket should be replaced to make it compatible.
The appliance MUST be connected to an efficient earth or ground tap.
The supply lead plug in fact incorporates a special earth or ground contact for this purpose. If by any chance the sockets of your domestic wiring system are not earthed, the appliance must be connected to a separate earth or ground wire by a qualified electrician, in accordance with existing safety regulations.
The manufacturer declines to accept any liability if this
This appliance complies with E.E.C. directive no. 87/308 of 2.6.87 relative to radio interference suppression.
This appliance complies with the following E.E.C. Directives:
-73/23 EEC of 19.2.73 (Low Voltage Directive) and subsequent modifications;
-89/336 EEC of 3.5.89 (Electromagnetic Compa- tibility Directive) and subsequent modifications.
Cleaning the appliance’s interior
Before using the appliance for the first time, wash all internal parts with lukewarm water and neutral soap so as to remove the typical «new» smell and then drv thoroughly.
Do not use detergents or abrasive powders as these will damage the finish.
Instructions for total built-in
Door reversibility
Remove the pins (P) and (P1).
Remove pins (P) from both sides and the door. Remove the middle hinge (A) and refit it on the opposite side. Refit the door and pin (P) on the left side. Remove pin (P1) from the right side.
Housing’s dimensions
Height | 1580 mm |
Depth | 550 mm |
Width | 560 mm |
Fig. 1
P | P |
| A |
P1 | P1 |
D112 |
|
| 13 |