Following operations are to be done on the basis of figures and explanations:
Break the circuit of the appliance.
Tilt back the appliance carefully being careful so that the compressor cannot touch the floor. It is recommended to ask another person for help, who can keep the appliance at this position safely.
Remove carefully (e.g. with a knife) the covering nails of screws fixing the bottom cover grid, then the cover grid can be removed by unscrewing the
Dismount the bottom door holder of the freezer by removing the screws (2 pieces) and the fill plates (2 pieces).
Take off the door of the freezer by pulling it slightly downwards.
Dismount the double door holder by removing the screws (2 pieces) and the fill plates (2 pieces).
Take off the door of the refrigerator by pulling it slightly downwards.
Unscrew the top door holding pin of the refrigerator, then screw it back on the other side.
Remove the covering nails of the double door holder on the left side and put them to the other side.
Fit the door of the refrigerator to the top door holding pin.
Fix the double door holder onto the left side using the screws (2 pieces) and fill plates (2 pieces). Be careful that the door edge of the refrigerator is parallel with the edge of the mantle.
Fit the door of the freezer to the double door holding pin.
Fix the bottom door holder onto the left side using the screws (2 pieces) and fill plates (2 pieces). Be careful that the door edge of the freezer is parallel with the edge of the mantle.
Pull out the cover element of the cover grid in the direction of arrow (1) and place it and contrary side
(2).
Put the cover grid back and fix it with the plate- screws (2 pieces), then put the covering nails back.
Put the appliance to its place, set it level and apply voltage to it.
In case you do not want to perform the procedures above, call the nearest
Electrical connection
This refrigerator is designed to operate on a 230 V AC (~) 50 Hz supply.
The plug must be put into a socket with protective contact. If there is no such, it is recommended to get an electrician to fit an earthed socket in compliance with standards near the refrigerator.
GB |
This appliance complies with the following E.E.C. Directives:
73/23 EEC of 19.02.73 (Low Voltage Directive) and subsequent modifications,
89/336 EEC of 03.05.89 (Electromagnetic Compatibility Directive) and subsequent modifications.
33
