Zanussi ZKG6010 Moving your appliance, For your safety, Location of appliance, above the

Moving your appliance

•You may damage some soft or badly fitted floor coverings when you move the appliance. The floor covering under the appliance should be securely fixed so it does not ruck up when you move the appliance across it. Alternatively you could remove the floor covering. This appliance is heavy and care must be taken when moving it. Do not try to move the appliance by pulling the door handles.

•To move the appliance, open the grill door. Raise the appliance off its front feet by lifting it from inside the oven. Pull the appliance forward. When you replace the appliance push it back to the stop and make sure there is the same gap at each rear corner.

For your safety

•Do not try to disconnect the appliance from the gas supply if the supply pipe does not have a bayonet connection, as described in the installation instructions. If this is the case contact the person who installed the appliance.

Location of appliance

•This appliance must not be installed in a bed-sitting room of volume less than 20m3 or in a bathroom, shower room or garage. It is essential that the appliance is positioned as shown.

30

•Shelves, wall cabinets and cooker hoods must be fitted a minimum of 650mm directly above the top of the hob (or greater for cooker hoods if recommended by manufacturers instructions) and 400mm above the hob when fitted in line with the outside of the appliance. If the units are

intended to be fitted adjacent to the appliance but less than 400mm

above the

hob, then a minimum space of

50mm must be maintained between the

sides of the unit and the

appliance.