•Curtains must not be fitted immediately behind the appliance or within 150mm of the sides of the hob. If fitted next to or between two base units a minimum space of 2mm must be left between each unit and the sides of the appliance. The levelling feet fitted to the appliance will achieve a nominal height to hob of 900mm + 20mm.
Leveling the appliance
•Adjustment to suit floor conditions or height is obtained by rotating clockwise or anti clockwise the feet at the front and rear of the appliance. A spirit level should be placed on one of the shelves to confirm the appliance is correctly leveled.
Connecting to electricity supply
WARNING!
This appliance must be earthed.
Do not earth this appliance to the gas supply piping.
Connect to 230-240 A.C supply only.
•Connection to the electricity supply should be made via a properly earthed, readily accessible wall socket. Which is adjacent to, but not directly above and not more than 1.7m away from the appliance and capable of electrical isolation. The cooker point should be within 1.7m of the appliance to make it accessible to switch off the appliance in case of emergency. The mains lead should be routed so that it cannot touch hot parts of the cooker i.e. the back panel above a height of 650mm from the floor.
•Should this plug not fit the socket outlet in your home it should be cut off and replaced with a suitable plug as outlined below.
34
•If the moulded plug is cut from the cable for any reason it must be destroyed or disposed of safely, as protruding wires will be an electrical shock hazard.
If the fitted plug is removed.
•The flexible mains lead must be correctly connected as below to
IMPORTANT!
The wires in the mains lead fitted to the appliance are coloured in accordance with the following code.
Green and yellow
Blue
Brown
•As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: -
•The wire, which is, coloured green and yellow must be connected to the terminals in the plug, which is marked with the letter E or
by the earth symbol (
) or coloured green or green and yellow.
