Zanussi ZOU 363 user manual Instructions for the Installer, Electrical connection

Instructions for the Installer

The instructions given below are designed specifically for a qualified installer and should aid him or her to perform all installation, adjustment, and maintenance operations with absolute precision and in compliance with all current legislation and regulations. We strongly recommend that all operations for the installation of your cooker be carryed out by Qualified Personnel in accordance with existing rules and regulations.

Electrical connection

Priortomakingtheelectricalconnection,makesurethat:

—the protection fuse and the domestic wiring system are suitable to carry the total electric load of the oven (see rating plate);

—your domestic wiring system has an efficient earth connection in compliance with rules and laws in force;

—the wall socket or the omnipole switch used for the electrical connection can easily be reached after the oven is built in.

This appliance is delivered without an electric supply cable, therefore, you will have to fit to it a supply cable with standard plug,suitableforthetotalelectricloadshownontheratingplate. Theplugistobeinsertedintoasuitablewallsocket.Ifyourequire a direct connection to the electric network (mains), it will be necessary to fit between the appliance and the mains an omnipole switch, with a minimum gap between contacts of 3 mm,suitablefortherequiredloadandincompliancewithrulesin force.Thegreen&yellowgroundwiremustnotbeinterruptedby the switch, and should be 2-3 cm longer than the phase and neutral wires. The supply cable must in all cases be laid out in such a way as to ensure that it does not reach at any given pointatemperature50°Chigherthantheambienttemperature. Suitable power supply cables are the following types, consideringtherespectivenecessarysectionofcable:H07RN- F, H05 RN-F, H05 RR-F, H05 VV-F, H05 V2V2-F (T90), H05 BB-F.

Connecting the terminal board

Theapplianceincorporatesaneasilyaccessible6-poleterminal boardwhosejumpers(bridges)arealreadypre-setforoperation on 400 V tri-phase with neutral wire (Fig. 9). In case a different mainsvoltageispresent,thejumpersontheterminalboardmust be rearranged as shown in the diagram (Fig. 10). The ground

cablemustbeconnectedtoterminal .Afterconnectingthe

supplycabletotheterminalboard,secureitwithajunctionclamp.

Electrical connection with the hob

This oven can be connected to hobs indicated in the paragraph "Technical data". The socket for connecting the hob is located at the top of the oven cabinet. The hobs come complete with connecting leads for the hot plates/ heat areas and ground cable; these leads feature plug-in connectors. Connection of the hob to the oven is carried out by plugging-in these connectors to the corresponding oven socket.

The plug-to-socket connection design is such as to prevent possible wrong plugging-ins.

The Manufacturer disclaims any liability in case these accident-preventing rules are not observed.

Fig. 9

	1		2	3	4	5
		230V 3~
	Ø 4x2,5mm² L1			L2		L3 PE
		1	2	3	4	5
		230V 1~
	Ø 3x2,5mm² L1				N		PE
		1	2	3	4	5
		400V 2N~
	Ø 4x2,5mm² L1 L2							PE
					N
		1	2	3	4	5
Fig. 10		400V 3N~
								PE
	Ø 5x1,5mm² L1 L2 L3 N

30