1.Remove the screw from the lamp cover.
2. Remove the lamp cover (refer to the illustration).
3.Replace the used lamp with a new lamp of the same
power and specifically designed for household ap- pliances (the maximum power is shown on the lamp cover).
4.Install the lamp cover.
5.Tighten the screw to the lamp cover.
6.Connect the plug to the mains socket.
7.Open the door. Make sure that the light comes on.
Closing the door
1.Clean the door gaskets.
2.If necessary, adjust the door. Refer to "Installation".
3.If necessary, replace the defective door gaskets. Contact the Service Center.
Technical data
Dimension |
|
Height | 815 mm |
Width | 596 mm |
Depth | 550 mm |
Rising Time | 13 h |
Voltage | |
Frequency | 50 Hz |
The technical information are situated in the rating plate on the internal left side of the appliance and in the energy label.
Installation
Caution! Read the "Safety Information" carefully for your safety and correct operation of the appliance
before installing the appliance.
Positioning
This appliance can be installed in a dry, well ventilated in- door (garage or cellar) also, but for optimum performance install this appliance at a location where the ambient tem- perature corresponds to the climate class indicated on the rating plate of the appliance:
Climate
class
SN
N
ST
T
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
9
