Problem
Unusual noises
Possible cause
Appliance is not level .
The appliance is touching the wall or other objects .
Acomponent , e . g . a pi pe , on the rear of the appliance is touching another part of the appliance or the wall .
Solution
Re - adjust the feet .
Move the appliance slightly .
If necessary , carefully move the component out of the way .
If the malfunction shows again , contact the Service Center .
These data are necessary to help you quickly and correctly . Write the necessary data here , refer to the rating plate .
Model descri ption . ..................................
(Mod . )
Product number ...................................
(PNC)
Serial number ...................................
(S . N . )
Replacing the lamp
Caution! Before replacing the lamp , shall disconnect the appliance from mains
power supply ..
Lamp specification: 220 - 240V , max . 15W
Follow below process to replace the lamp:
1 . Set the temperature regulation knob at num -
ber “0 ” to switch off the appliance .
2 . Unplug the appliance to make sure the
appliance is disconnected from main power supply .
3 . Remove the screw of the lamp cover .
4 . Pull the lamp cover out .
5 . According to the direction showed in below picture , unscrew the lamp .
6 . Fit new lamp according to the opposite direction , then replace the lamp cover and screw .
7 . Plug in the appliance and regulate the knob to right position .
Technical data
For further technical information please refer | to the rating on the internal left | side of the appliance and in the |
energy label. |
|
|
|
|
|
|
|
|
Dimensions |
|
|
Height | 1687 mm | |
Width | 554 | mm |
Depth | 551 | mm |
Rising Time | 10 hours | |
Installation |
|
|
Read the Safety information”carefully for your safety and correct operation of the appliance before installing the appliance .
Positioning
Install this appliance at a location where the ambient temperature corresponds to the climate class indicated on the rating plate of the appliance:
7