Zanussi ZRB227XO, ZRB227WO user manual Climate class, Location

Climate class	Ambient temperature
SN	+10 o C to +32 o C
N	+16 o C to +32 o C
ST	+16 o C	to	+38 o C
T	+16 o C	to	+43 o C

Location

The appliance should be installed well away from sources of heat such as radiators , boilers , direct sunlight etc . Ensure that air can circul - ate freely around the back of the cabinet . To ensure best performance , if the appliance is positioned below an overhanging wall unit , the minimum distance between the top of the cabi - net and the wall unit must be at least 100 mm . Ideally , however , the appliance should not be positioned below overhanging wall units . Accu - rate leveling is ensured by one or more adjust - able feet at the base of the cabinet .

Warning! It must be possible to disconnect the appliance from the mains power suppl - y; the plug must therefore be easily acce - ssible after installation .

Electrical connection

Caution! Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person .

Warning! This appliance must be earthed . The manufacture declines any liability should these safety measures not be observed .

12

3

5

4

Important! The wires in the mains lead are colored in accordance with the following code:

1	Green and Yellow:	Earth
3	Brown:	Live

8

5 Blue: Neutral

As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug , proceed as follows:

1 . Connect the wire coloured green and yellow to the terminal marked either with the letter

“E ” or by the earth symbol or coloured green and yellow .

2 . Connect the wire coloured blue to the termi -

nal either marked with the letter “ N ” or col - oured black .

3 . Connect the wire coloured brown to the ter -

minal either marked with the “ L ” or colour - ed red .

4 . Check that no cut , or stray strands of wire is present and the cord clamp 4 is secure

over the outer sheath .

5 . Make sure the electricity supply voltage is the same as that indicated on the appliance rating plate .

6 . Switch on the appliance .

The appliance is supplied with a 13 amp plug fitted 2 . In the event of having to change the fuse in the plug supplied , a 13 amp ASTA approved (BS 1362) fuse must be used .

Warning! A cut off plug inserted into a 13 amp socket is a serious safety (shock) ha - zard . Ensure that it is disposed of safety .

Levelling

The appliance should be level in order to elim - inate vibration . To make the appliance level , it should be upright and both adjusters should be firmly contacted with the floor . You can also adjust the level by screwing out the appropriate level adjuster at the front (use your fingers or a suitable spanner) .

Door reversibility

The side at which the door opens can be

changed from the left side ( as supplied) to the right side , if the installation site requires . Before you start lay the refrigerator on its back in order to gain access to the base , you should rest it on soft foam or similar material to avoid damaging the cooling pi pes at the rear of refri - gerator .

1 . Stand the refrigerator , use a flat bladed screw driver to remove the 4 screw covers in the refrigerator lid .