What to do if...
Warning: Before troubleshooting, disconnect the power supply. Only a qualified electrician of competent person must do the troubleshooting that is not in this manual.
Important: There are some sounds during normal use (compressor, refrigerant circulation).
Malfunction
The wine is too warm.
Heavy build up of the frost, possibly also on the door seal.
Unusual noises.
The compressor does not start immediately after changing the temperature setting.
Water on the floor.
Possible cause
Temperature is not properly adjusted.
Door was open for an extended period.
The appliance is near a heatsource.
Door seal is not air tight (possibly after changing over the hinges).
Appliance is not level.
The appliance is touching thewall or other objects.
A component, e.g. a pipe, on rear of the appliance is touching another part of the appliance or the wall.
This is normal, no error has occurred.
Water drain hole is blocked.
Remedy
Please look in the “Use” section.
Open the door only as long as necessary.
Please look in the “Installation” section.
Carefully warm the leaking sections of the door seal with a hair dryer (not hotter than approx.
50 °C). At the same time shape the warmed door seal by hand such that it sits correctly.
Readjust the feet.
Move the appliance slightly.
If necessary, carefully bend the component out of the way.
The compressor starts after a period of time.
See the “Cleaning” section.
14
