ASSEMBLY INSTRUCTIONS
NOTE: For additional references to the parts listed in the following pages, refer to the
Assembly Diagrams on pages 28, 29, 30, 31, and 32.
To Assemble The Base:
1.Place one Table (8A) upside down on a level floor surface. Attach a Support Board 1 (2A) to opposite corners of the Table, and attach a Support Board 2 (1A) to the two remaining opposite corners of the Table using Screws (3A), Washers (6A), and Plastic Nuts (7A). Repeat this procedure for the remaining two Tables (8A). (See Figure F.)
2.Hold Support Leg 1 (4A) and Support Leg 2 (9A) together with their mounting holes aligned. Then, align the mounting holes of the Support Legs with the three mounting holes in Support Board 1 (2A) and Support Board 2 (1A). Secure the Support Legs to the Support Boards, using Screws (3A), Washers (6A), and Plastic Nuts (7A). (See Figure F.)
|
|
| SUPPORT LEG 2 | SCREW (3A) |
|
| |
SUPPORT LEG 1 |
| (9A) |
|
| |||
| WASHER (6A) |
| |||||
|
| ||||||
(4A) |
|
|
|
| END | ||
|
|
|
| PLASTIC NUT (7A) | |||
|
|
| |||||
|
|
|
|
|
|
| VIEW |
|
|
|
|
|
|
| (UPSIDE DOWN) |
TABLE (8A)
FRONT
VIEW
(UPSIDE DOWN)
TABLE (8A)
TABLE (8A)
SUPPORT | SUPPORT |
|
BOARD 2 | BOARD 1 | FIGURE F |
(1A) | (2A) |
|
FRONT
VIEW
(RIGHT SIDE UP)
SKU 91130 | For technical questions, please call | Page 12 |
