Harbor Freight Tools 91130 To Attach The Motor Assembly, To Attach The Fence

4.Screw a Nut (24B) downward on each of the eight Hex Screws (23B). Insert the Hex Screws downward through the eight mounting holes located on the Main Table (20B). Make sure the Nuts are above the mounting holes. Then, screw a Nut (24B) upward on each of the eight Hex Screws to secure the Hex Screws to the Main Table. (See Figure J.)

To Attach The Motor Assembly:

1.Lower the Adjustment Board (17D) with its pre-attached Motor Assembly through the top of the Main Table (20B). Position the Adjustment Board and Motor Assembly so that its Power Cord is on the left hand side and the Spindle Lock Lever (22E) is on the right hand side. Continue lowering the Adjustment Board until it sits on the eight Hex Screws (23B). (See Figures J and K.)

ADJUSTMENT BOARD (17D)		SCREW
			(16D)
	. .
. .
			MAIN
			TABLE
					SPINDLE
			(20B)
				MOTOR		LOCK
						LEVER
				ASSY.
						(22E)

FIGURE K

2.NOTE: The height of the Adjustment Board (17D) can be adjusted by inserting a hex wrench (not included) through the Adjustment Board and adjusting each Hex Screw (23B) individually. Once adjusted, secure the Adjustment Board to the Main Table (20B) with four Screws (16D). (See Figures J and K.)

To Attach The Fence:

1.The Upper Fence (16C) is supplied with six Nuts (11C) already fitted to one channel (groove) of the Upper Fence. The furthest two Nuts on each end of the Upper Fence are for attaching the two Fence Supports (10C) to the Upper Fence. The middle two Nuts are for attaching the Dust Port Box (24C) to the Upper Fence. (See Assembly Diagram C.)

SKU 91130 For technical questions, please call 1-800-444-3353. Page 16