2.Position the Upper Fence (16C) on the Main Table (20B).
3.Use two Screws (9C) to attach a Fence Support (10C) to the back of the Upper Fence (16C), making sure to use two of the outermost
4.Slide the two Fence Supports (10C) along the Upper Fence (16C) until the hole in the horizontal leg of the Fence Supports is above the transverse (right angle) channel at the rear of the Main Table (20B).
(See Assembly Diagram C and Figure L.)
TRANSVERSE CHANNEL
MAIN TABLE
(20B)
TRANSVERSE
CHANNEL
FIGURE L
5.NOTE: The screw heads of the Screws (22C) locate in a channel under the Main Table (20B). This channel holds the Screws and prevents the Screws from turning when the Fence Locking Knobs (8C) are tightened or loosened.
(See Assembly Diagram C.)
6.Insert the screw head of a Screw (22C) into the channel under the Main Table (20B) so that the threaded portion of the Screw passes through the hole in a Fence Support (10C). Tighten the Screw, using a Fence Lock Knob (8C) and Large Washer (7C). (See Assembly Diagram C.)
7.Tighten the Screws (9C) holding the Fence Support (10C) to the Upper Fence (16C). (See Assembly Diagram C.)
8.Repeat Steps #6 and #7 at the other end of the Upper Fence (16C).
To Attach The Dust Port Assembly And Protector:
1.Position the Dust Port Assembly (26C) and Protector (23C) to the middle of the
SKU 91130 | For technical questions, please call | Page 17 |
