Zanussi ZSF 4143 user manual Set the water softener, Water hardness Clarke Mmol/l, Use of salt

IMPORTANT!

If the drying results are not satisfactory we rec- ommend that you:

1.Fill up the rinse aid dispenser with rinse aid.

2.Set the rinse aid dosage to position 2.

If you decide in future to use separated deter- gents, we advise that you:

–Fill up the salt and rinse aid container.

–Adjust the water hardness setting to the highest level and perform 1 normal washing programme without loading any dishes.

–Adjust the water hardness setting according to the hardness of the water in your area.

–Adjust the rinse aid dosage

Set the water softener

The dishwasher is equipped with a water soft- ener designed to remove minerals and salts from the water supply, which would have a det- rimental or adverse effect on the operation of the appliance.

The higher the content of these minerals and salts, the harder your water is.

Water hardness is measured in equivalent scales, Clarke degrees, French degrees (°TH)

and mmol/l (millimol per litre - international unit for the hardness of water).

The softener should be adjusted according to the hardness of the water in your area. Your local Water Authority can advise you on the hardness of the water in your area.

Water hardness

Clarke	°TH	mmol/l
64 - 88	91 - 125	9,0- 12,5
53 - 63	76 - 90	7,6 - 8,9
46 - 52	65 - 75	6,5 - 7,5
36 - 45	51 - 64	5,1 - 6,4
28 - 35	40 - 50	4,0 - 5,0
23 - 27	33 - 39	3,3 - 3,9
18 - 22	26 - 32	2,6 - 3,2
13 - 17	19 - 25	1,9 - 2,5
5 - 12	7 - 18	0,7 - 1,8
< 5	< 7	< 0,7

The water softener must be set in both ways: manually, using the water hardness dial and electronically.

Adjusting the water hardness

setting

manually	electronically
2	level 10
2	level 9
2	level 8
2	level 7
2	level 6
2	level 5
1	level 4
1	level 3
1	level 2
1	level 1

Use of salt

yes

yes

yes

yes

yes

yes

yes

yes

yes

no

8