Building the appliance in under a worktop
1.The dimensions of the recessed installation area must correspond with those indicated in the figure.
2.Installation kit
600 |
|
|
550 |
| |
min. |
| |
|
| 600 |
DO013 |
|
|
1xB |
| 2xC |
1xA |
|
|
|
| 12 |
2 | 1 |
|
2 | 1 | 2 |
1 |
| |
|
| |
3.Two cabinet securing brackets are supplied with the installation pack. They need to be assembled onto the cabinet prior to cabinet being pushed into the Kitchen aperture.
-To fit these brackets remove the two screws at the top left and right hand front corners of the cabinet.
-Position the two brackets as shown in the figure and replace the two securing screws.
4.Push the appliance into place. The plug socket necessary for connection of the appliance to the electricity supply should be positioned, so that the plug is not placed in the recess.
5.To adjust the height proceed as follows:
-Loosen or tighten the two front feet.
-The rear feet are adjusted by turning the screw in the front kick plate to the left or right.
Left hand | Right hand |
bracket | bracket |
1/a |
|
- |
|
2Li89 | + |
|
19
