Zanussi ZUD 9154 Maintenance And Cleaning, Internal cleaning, When the appliance is not in use

Models: ZUD 9154

1 24
Download 24 pages 43.01 Kb
Page 7
Image 7
MAINTENANCE AND CLEANING

MAINTENANCE AND CLEANING

Before any maintenance or cleaning work is carried out, DISCONNECT the appliance from the ELEC- TRICITY supply.

Warning

This appliance contains hydrocarbons in its cooling unit maintenance and recharging must therefore only be carried out by authorised technicians.

Internal cleaning

Clean the inside and accessories with warm water and bicarbonate of soda (5ml to 0.5 litre of water). Rinse and dry thoroughly.

NEVER USE DETERGENTS, ABRASIVE POW- DERS, HIGHLY PERFUMED CLEANING PROD- UCTS OR WAX POLISHES, TO CLEAN THE INTE- RIOR AS THESE WILL DAMAGE THE SURFACE AND LEAVE A STRONG SMELL.

Clean the drain hole of the water trough at regular intervals and make sure that the drain hole is never obstructed, so that the defrost water may flow freely.

Important

Do not use abrasive products.

1.Unscrew the light cover and then pull it outward by pressing as shown in the figure. Unscrew the bulb and replace it with a new 15 watt bulb (avail- able from your nearest Zanussi Service Force centre).

D411

2.Replace the light cover by sliding it into its original position and replacing the screw.

When the appliance is not in use

When the appliance is not in use for long periods, disconnect from the electricity supply, empty all foods and clean the appliance, leaving the door ajar to prevent unpleasant smells.

Periodic cleaning

The appliance is equipped with a ventilation grid. Keep clean to guarantee good ventilation and good working order of the appliance.

An accumulation of dust will affect the performance of the appliance and cause excessive electricity con- sumption.

The structure of the appliance permits cleaning of the rear zone close to the wall, using a vacuum cleaner.

1.Remove the plinth (1), then the ventilation grid (2);

2.Carefully pull the air deflector out (3), checking that there is no water left from the defrosting.

3

2

1

S.I.013

 

 

Changing the light bulb

Should the interior light fail to work, first switch off the appliance and disconnect from the electricity supply, then replace the bulb as follows:

7

Page 7
Image 7
Zanussi ZUD 9154 manual Maintenance And Cleaning, Internal cleaning, When the appliance is not in use, Periodic cleaning