Electrical connection
Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. This appliance must be earthed.
The manufacturer declines any liability should these safety measures not be observed.
Electrical Requirements
Before switching on, make sure the electricity supply voltage is the same as that indicated on the appliance rating plate.
The appliance is supplied with a 13amp plug fitted. In the event of having to change the fuse in the plug supplied, a 13amp ASTA approved (BS1362) fuse must be used.
Should the plug need to be replaced for any reason. The wires in the mains lead are coloured in accoordance with the following code:
Green and yellow | |
Blue | |
Brown |
Door Reversal
1.Close the cabinet and pull out the plug from the electrical outlet.
2.Remove the ventilation grille. There is a part on the grille that can be removed. Remove it and transfer to the opposite side.
3.Support the cabinet on a wooden block when it is laid down. It will be easier to grip under the cabinet when resupporting to an upright positon.
4.On the upper part of the cabinet. Put the hinge pin on the other side.
5.On the lower part of the cabinet. Unscrew the hinge. Move the hinge pin and plastic cover. Secure the hinge on the other side.
6.Raise the cabinet and replace the ventilation grille.
7.Unscrew the handle. Carefully press in the plastic plugs on the opposite side using a punch. Secure the handle in the plug holes. Then press the supplied plastic plugs into the holes to which the handle was previously fitted.
8.Put the cabinet in position. Check that it stands straight. See the section "Positioning the cabinet".
The wire coloured green and yellow must be connected to the terminal marked with the letter "E"
or by the earth symbol 
or coloured greeen and yellow.
The wire coloured blue must be connected to the terminal marked "N" or coloured black
The wire coloured brown must be connected to the terminal marked "L" or coloured red.
Upon completion there must be no cut, or stray strands of wire present and the cord clamp must be secure over the outer sheath.
1 |
2 |
3 |
4 |
5 |
7 |
Zanussi 818 15 |
16
