Zebra Technologies 980293-001 iv

The printer and power supply should never be operated in a

location where either one can get wet. Personal injury could

result.

Always use high quality Eltron approved labels, tags and

transfer ribbons. If adhesive backed labels are used that DO

NOT lay flat on the backing liner, the exposed edges may stick

to the label guides and rollers inside the printer, causing the

label to peel off from the liner and jam the printer. Eltron

approved supplies can be ordered from your ELTRON dealer.

For the name of a dealer in your area, call the nearest Eltron

office (located on the back of this manual).

If you should run out of labels while printing, DO NOT turn the

power switch OFF (0) while reloading or data loss may result.

The printer will automatically a new label roll is loaded.

The discharge of electrostatic energy that accumulates on the

surface of the human body or other surfaces can damage or

destroy the print head or electronic components used in this

device.

DO NOT TOUCH the print head or the electronic components

under the top cover.

The print head becomes hot while printing. To protect from

damaging the print head and risk of personal injury, avoid

touching the print head. Useonly the cleaning pen to perform

maintenance.

iv 980293-001Rev. A