68
Status Light Error Resolutions
5.The media is out.
•Follow the instructions for Loading Roll Media on page 11 in the Getting Started section, and then press the Feed button to resume printing.
The ribbon is out.
• The printer has sensed the end of the ribbon roll. Replace the ribbon.
The printhead is open.
•Close the top cover and then press the Feed button to resume printing.
6.The printer is paused.
•Press the Feed button to resume printing.
7.The printhead is over temperature.
•Printing will stop until the printhead cools to an acceptable printing temperature. When it does, the printer will automatically resume operation.
8.FLASH memory is not programmed.
•Return the printer to an authorized reseller.
9.The printhead or motor has had a critical failure.
•Return the printer to an authorized reseller.
10.The printer is defragmenting memory.
Caution • Do NOT turn off the printer power during defragmentation. Doing so can damage the printer.
•Defragmentation is a normal operation of the printer – necessary to manage the memory space for optimal use. The printer will defragment its memory both after a factory default and when the printer detects that a defragment is required.
When the printer is in this condition, allow it to finish defragmenting. If this warning occurs frequently, check the label formats. Formats that frequently and repeatedly write to and erase from memory my cause the printer to defragment often. Using formats that avoid frequent and repeated memory write/erase event will minimize the need for defragmentation.
•If this warning condition does not go away, contact Technical Support. The printer requires service.
| GC420t™ User Guide | 5/22/2012 |
