INTRODUCTION

NOTE: Zebra Technologies Corporation is not liable for personal injury or damage to any equipment caused by the improper installation of this equipment to any power source.

The Zebra RCLI-AC Charger system is designed to allow Zebra Technology QL or RW series Mobile Printers to run off an A.C. power source. It does this by providing intelligent charging capabilities for the printer’s battery allowing it to run for prolonged periods of time off A.C. power .

Follow these installation instructions closely to ensure safe, reliable performance of your QL series printer.

The printer is powered with its own battery which is charged by the RCLI-AC Series Charger System which in turn runs off your facility’s A.C. power Your facility’s A.C. power delivery system must be properly installed and maintained to minimize power spikes and electrical “noise” .

Faulty electrical components within your facility’s A.C. wiring system can create electrical noise severe enough to defeat the electrical filtering that is built into the printer. When this

happens, printers and any data device communicating to them can behave unpredictably.

A.C. Power module

Charger

Module

QL Series Printer

The RCLI-AC Charger is supplied with an output cable with a special plug for the printer’s charging port, and an input power module which plugs into an A.C. power source. Refer to the installation section of this manual for more information.

NOTE: Failure to install this equipment per these instructions will void the warranty.

Figure 1

RCLI-AC Charging System

pg. 4 of 10

AM16905-001 Rev. A