Zebra Technologies RXi4 manual Load Ribbon, To load ribbon, complete these steps

16

Load Ribbon

Load Ribbon

Use the instructions in this section to load ribbon for use with thermal transfer labels. For direct thermal labels, do not load ribbon in the printer. Remove used ribbon from the ribbon take-up spindle each time you change the roll of ribbon (see Remove Used Ribbon

on page 22).

Caution • When you are loading media or ribbon, remove all jewelry that could come into contact with the printhead or other printer parts.

Important • Use ribbon that is wider than the media to protect the printhead from wear. Ribbon must be coated on the outside (refer to the User Guide for more information).

To load ribbon, complete these steps:

1.Align the arrow (1) on the ribbon take-up spindle knob with the notch (2) in the ribbon take-up spindle.

21

2.Align the segments of the ribbon supply spindle.

3.Position the ribbon with the loose end unrolling clockwise.

P1008806-002 Xi4™/RXi4™ Quick Reference Guide 3/8/10