Zenith LMG340 warranty Troubleshooting, Symptom, Cause, Possible Solution

Troubleshooting

Check the following guide for the possible cause of a problem before contacting service.
Symptom		Cause		Possible Solution
No power.	•	The power cord is disconnected.	•	Plug the power cord into a wall power
				outlet securely.	REFERENCE
No sound.	•	The audio cables are not connected	•	Insert the audio cables into the jacks
		securely.		securely.
	•	The external source equipment’s power	•	Turn on the power of the external equip-
		is switched off.		ment connected with the audio cables.
	•	The Digital Audio Output is set	•	Set the Digital Audio Output to the cor-
		to the wrong position.		rect position, then turn on the unit again
				by pressing POWER.
The unit does not start	•	No disc is inserted.	•	Insert a disc.
playback.
	•	An unplayable disc is inserted.	•	Insert a playable disc.
	•	The disc is placed upside down.	•	Place the disc with the playback side
				down.
	•	The disc is not placed within the guide.	•	Place the disc on the disc tray correctly
				inside the guide.
	•	The disc is dirty.	•	Clean the disc.
The remote control	•	The remote control is not pointed at the	•	Point the remote control at the remote
does not work properly.		remote sensor on the unit.		sensor on the unit.
	•	The remote control is too far from the	•	Operate the remote control within about
		unit.		23 ft (7 m).
	•	There is an obstacle in the path of the	•	Remove the obstacle.
		remote control and the unit.
	•	The batteries in the remote control are	•	Replace the batteries with new ones.
		exhausted.

19