Zenith P60W38H manual External A/V Source Setup, DVD Setup, DTV Setup, Component Input ports

Installation

External A/V Source Setup

How to connect

1.Connect the provided BNC-RCA adapter to the monitor’s VIDEO INPUT.

2.Connect the audio and video cables from the external equip- ment's output jacks to the monitor input jacks, as shown in the figure.

When connecting the monitor to external equipment, match the jack colors (Video = yellow, Audio Left = white, and Audio Right = red).

How to use

1.Use the INPUT SELECT button on the remote control to select Video.

2.Operate the corresponding external equipment. Refer to external equipment operating guide.

R AUDIO L	Y	PB	PR			R AUDIO L (MONO)
AUDIO INPUT	COMPONENT INPUT			S-VIDEO	VIDEO	AUDIO INPUT
					INPUT

R AUDIO L VIDEO

Camcorder

Video Game Set

DVD Setup

R AUDIO L	Y	PB	PR			R AUDIO L (MONO)
AUDIO INPUT	COMPONENT INPUT			S-VIDEO	VIDEO	AUDIO INPUT
					INPUT

How to connect

1.Connect the DVD video outputs to the COMPONENT (Y, PB, PR) INPUT jacks and connect the DVD audio outputs to the AUDIO INPUT jacks on the monitor, as shown in the figure.

2.If your DVD only has an S-Video output jack, connect this to the S-VIDEO input on the monitor and connect the DVD audio outputs to the AUDIO INPUT jacks on the monitor, as shown in the figure.

(R) AUDIO (L) B R

DTV Setup

or

DVD

How to use

1.Turn on the DVD player, insert a DVD.

2.Use the INPUT SELECT button on the remote control to select

Component. (If connected to S-VIDEO, select the S-Videoexternal input source.)

3. Refer to the DVD player's manual for operating instructions.

• Component Input ports

To get better picture quality, connect a DVD player to the compo- nent input ports as shown below.

(R) AUDIO (L) S-VIDEO

Component ports of the	Y	PB	PR
Monitor
Video output ports	Y	Pb	Pr
	Y	B-Y	R-Y
of DVD player	Y	Cb	Cr
	Y	PB	PR

-To watch digitally broadcast programs, purchase and connect a digital set-top box.

-This monitor supports HDCP (High-bandwidth Digital Contents Protection) protocol for DVI DTV (480p,720p,1080i) mode.

How to connect

1.Use the monitor’s COMPONENT (Y, PB, PR) INPUT, RGB or DVI jack for video connections, depending on your set-top box connector. Then, make the corresponding audio connections.

How to use

1.Turn on the digital set-top box. (Refer to the owner’s manual for the digital set-top box.)

2.Use INPUT SELECT on the remote control to select Component, RGB, or DVI.

Signal	Component	RGB-DTV,DVI-DTV
480i	Yes	No
480p	Yes	Yes
720p	Yes	Yes
1080i	Yes	Yes

					R AUDIO L	Y	PB	PR			R AUDIO L (MONO)
RS-232C INPUT	DVI INPUT	RGB INPUT	AUDIO INPUT	RGB OUTPUT	AUDIO INPUT	COMPONENT INPUT			S-VIDEO	VIDEO	AUDIO INPUT
(CONTROL/SERVICE)										INPUT

	or	or
DVI-DTV OUTPUT (R) AUDIO (L)	RGB-DTV OUTPUT (R) AUDIO (L)	(R) AUDIO (L)	B	R

Digital Set-top Box

12 Plasma Display