BKZ4500DL / BKZ5000DL
6. Set up
INSTALLING HANDLE
•Mount the handle to the shaft tube and clamp it at a location that the edge of CE label is matched with the handle.
WARNING
•Stop tightening the screws when the gap A be- comes zero.
CE label
FLEXIBLE SHAFT
1.Remove the bolt located on the joint of the shaft tube.
2.Match the groove of the liner with the threaded hole and fix with screw securely.
(1)Bolt
(2)Joint
(3)Groove
3.While rotating the flexible shaft located on the opposite end from the liner, insert the flexible shaft into the joint until it is tightly connected. (Note that it is normal at this time for the flexible shaft not to project from the liner.)
(1)Flexible shaft (2)Liner (3)Clutch housing
4.Put the engine side end of the flexible shaft into the clutch housing, making the hole on the shaft upside. Push it on until the stopper catches the hole.
(1) Stopper
(2) Flexible liner
(3) Clutch housing
5.Pass the end of the wire on the side of the blade through the sleeve of the connector case.
6.Insert the end of the wire on the side of the blade into the end of the wire on the side of the engine, and put the sleeve over the connected part (Fig. 6).
7.Align the throttle wire and the sleeve with the hollow of the connector case and insert them into the connector case, and close the connector case. In order to close the connector case, align half the surface of the con- nector case with the other half surface and press the upper half surface strongly with your fingers.
(1)The end of the wire on the side of the engine
(2)Sleeve
INSTALLING CUTTING
ATTACHMENT GUARD
• A t t a c h t h e c u t t i n g attachment guard with the bolts provided to the shaft.
INSTALLING BLADE
1.Put the angled bar(1) into the side holes of the inner holder and the angle transmission.
2.Remove the nut (Lefthanded) and the outer holder(3) from the gearshaft.
3.Put the blade onto the inner holder(2). Make the marked side face the holder.
4.Put the outer holder(3) onto the gearshaft making the recessed side face the blade.
5.Fasten the blade by the nut and the cover(4).
INSTALLING LINE HEAD
1.While locking the gear shaft by inserting the supplied tool into the upper holder on the angle transmission, loosen and remove the nut
2.Detach the cover(1), fit the line head assembly to the gear shaft. Hand tighten it securely.
INSTALLING CUTTING
ATTACHMENT GUARD
FOR LINE HEAD
• When using line head, make sure to attach the guard skirt.
BALANCE UNIT
1.Put on strap and attach unit to strap.
2.Slide clamp up or down un- til unit balances with head aparting from the ground when using it.
(1)
(3) The end of the wire on the side of the blade
(4) Connector case
