eHT752S / eHT602D
7. Operation
STARTING ENGINE
WARNING
The cutting head will start moving upon the engine starts.
1.Feed fuel into the fuel tank and tighten the cap se- curely.
2.Rest the unit on a flat, firm place. Keep the cutting head off the ground and clear of surrounding objects as it will start moving upon starting of the engine.
3.Push the primer several times until overflown fuel flows out in the clear tube.
(a) Primer (b) Clear tube
4.When the engine is cool, move the choke lever to the closed position.
(a) Choke lever (b) Open (c) Close
5.Set the ignition switch to the “RUN” position.
(c)
(d) | (c) | d | |
b | |||
b |
| ||
|
| ||
| a | a | |
|
|
(a) Throttle lever (b) Ignition switch (c) RUN (d) STOP
6.While holding the unit firmly, pull out the starter rope quickly until engine fires.
IMPORTANT
•Avoid pulling the rope to its end or returning it by re- leasing the knob. Such actions can cause starter fail- ures.
7.Move the choke lever downward to open the choke. and restart engine.
8.Allow the engine to warm up for a several minutes before starting opertion.
NOTE
1.When restarting the engine immediately after stop- ping it, leave the choke open.
2.Overchoking can make the engine hard to start due to excess fuel. When the engine failed to start after several attempts, open the choke and repeat pulling the rope, or remove the spark plug and dry it.
STOPPING ENGINE
1.Release the throttle lever and run the engine for half a minute.
2.Shift the ignition switch to the “STOP” position.
IMPORTANT
•Except for an emergency, avoid stopping the engine while pulling the throttle lever.
NOTE
If the engine won't stop when setting the ignition switch to the stop position, close the choke lever and stop the engine.
In this case, please repair the machine at your nearest servicing dealer.
