Zenoah EHT752S, EHT602D Cutting Work, Hedge Trimming Techniques, Vertical cut, Horizontal cut

7. Operation

CUTTING WORK

WARNING

•Weather conditions and altitude may effect carburation.

•Do not allow anyone to stay close to the hedge- trimmer while working or while adjusting the car- buretor.

HOW TO USE : HANDLE (eHT602D)

•To reduce fatigue when trimming hedges, the handle can be swivelled through 90° to the left or right.

•Do not press the throttle during this operation!

Proceed as follows:

1.Free the handle by pressing the locking lever.

2.Turn the handle until the locking lever clicks into place.

3.When the handle is locked in its new position, you can apply the throttle again.

(1)handle

(2)locking lever

•You can swivel the handle even with the engine idling because the hedge-trimmer is equipped with a blade brake that maintains the blades at a standstill.

■HEDGE TRIMMING TECHNIQUES

Trim sides of a hedge first, and then the top.

Vertical cut:

•With the single-sided blade hedge-trimmer, model eHT752S always cut from the bottom up.

•With the 2-sided blade model eHT602D use an arc- ing cut from the bottom upwards, then downwards to use both sides of the blades.

eHT752S / eHT602D

G

B

Horizontal cut:

•In order to get the best cutting results, slightly tilt the blade (5÷10°) towards the cutting direction.

Cut slowly, specially with thick hedges.

WARNING

Always follow the safety precautions.

The hedge-trimmer must only be used to trim hedges or small bushes. It is forbidden to cut other types of material. Do not use the hedge-trimmer as a lever to lift, move or break objects, nor lock it on fixed sup- ports. It is forbidden to apply tools or applications that are not the ones indicated by the manufacturer onto the hedge-trimmer’s power take-off. Do not use it for pruning trees or cutting grass.

•Use only as much throttle as is needed to do the job. Excessive engine speed is unnecessary.

•Avoid cutting thick branches, for which will damage the blades and shorten the life of drive systems.

•Tilting the trimmer 5 to 10° to the cutting object will make the job easy and bring a good result.

•Always keep your body to the carburetor side of your trimmer, never on the muffler side.

•When a new machine is first operated, in the first few minutes grease may come out of the gear case. But, since this is excess grease, there is no cause for alarm. Just wipe it off with the engine stopped for next use.

•Always remember that the TIP of the line does cut- ting. You will achieve better results by not crowding the line into the cutting area. Allow the unit to trim at its own pace.

GB-11