Zenoah G3300EZ Maintenance, A log lying on the ground, A log hanging off the ground, Guide bar

G3300 / G3300EZ

A log lying on the ground

Saw down halfway, then roll the log over and cut from the opposite side.

A log hanging off the ground

In area A, saw up from the bottom one-third and finish by sawing down from the top. In area B, saw down from the top one-third and finish by sawing up from the bot- tom.

Cutting the limbs of Fallen Tree

First check to which side the limb is bent. Then make the initial cut from the bent side and finish by sawing from the opposite side.

Be alert to the springing back of a cut limb.

Pruning of Standing Tree

Cut up from the bottom, finish down from the top.

• Do not use an unstable foothold or ladder.

• Do not overreach.

•Do not cut above shoulder height.

•Always use both your hands to hold the saw.

7. Maintenance

Before cleaning, the inspecting or repairing the unit, make sure that engine has stopped and is cool. Disconnect the spark plug to pre- vent accidental starting.

■MAINTENANCE AFTER EACH USE

1. Oiling port

Dismount the guide bar and check the oiling port for clogging.

(1)

(1) Oiling port

2. Guide bar

When the guide bar is dismounted, remove sawdust in the bar groove and the oiling port.

Grease the nose sprocket from the feeding port on the tip of the bar.

(1) Oiling port

(2) Grease port

(3) Sprocket

3. Others

Check for fuel leakage and loose fastenings and dam- age to major parts, especially handle joints and guide bar mounting. If any defects are found, make sure to have them repaired before operating the saw again.

GB-12