Operation
■STARTING ENGINE WARNING
•Keep the blades clear of the surrounding as they will start moving upon starting of the engine.
1.When first starting up after putting fuel into the machine, push the priming pump until fuel runs out in the clear tube. Then close the choke. Choking may not be necessary when
2.Pull the throttle lever and push the lock button to set the lever in the START position.
3.[CHT2300B/CHT2300L only]
Slide the ignition switch to the engine side to set it in the ON position.
4.Rest the unit on a flat firm place. While holding the unit with your left hand on the starter housing, pull the starter knob quickly.
NOTE
•Avoid pulling the rope to its end or returning it by releasing the knob. Such actions can cause starter failures.
5.When the engine has started, gradually open the choke.
6.A l l o w the engine to warm up for a half minute before starting operation.
NOTE
•If the engine won't start after several attempts, open the choke and repeat pulling the rope or remove the spark plug and dry it.
■STOPPING ENGINE
1.Release the throttle lever and run the engine at idling speed for a half minute.
2.Stop the engine by the stop switch.
[HT2300A/HT2300L] Press on the stop button until the engine stops completely.
[CHT2300B/CHT2300L] Shift the ignition switch to the STOP position.
NOTE
•Except for an emergency, avoid stopping the engine while running it at high speed.
10