Zenoah CHT2310 Before Starting Engine, Starting the Engine, Never place the throttle into

5. For safe operation

NOTE

Check and follow the local regula- tions as to sound level and hours of operations for the product.

BEFORE STARTING

THE ENGINE

1.The area within a perimeter of 15 m of the person using the

product should be considered a hazardous area into which no one should enter. If necessary, yellow warning rope, warning signs should be placed around the pe- rimeter of the area. When work is to be performed simultaneously by two or more persons, care should also be taken to constantly look around or otherwise check for the presence and locations of other people working so as to maintain a distance between each person sufficient to ensure safety.

2.Check the condition of working area to avoid any accident by hit- ting hidden obstacles such as stumps, stones, cans, or broken glass.

IMPORTANT

Remove any obstacle before begin- ning work.

3. Inspect the entire unit for loose fasteners and fuel leakage. Make sure that the cutting attachment is properly installed and securely fastened.

STARTING THE ENGINE

1. Keep bystanders, especially chil- dren, and animals at least 15 m away from the operating point. If you are approached, immediately stop the engine.

2. The product is equipped with a centrifugal clutch mechanism, so the cutting attachment begins to move as soon as the engine is started by putting the throttle into the start position. When starting the engine, place the product onto the ground in a flat clear area and hold it firmly in place so as to ensure that neither the cutting part nor the throttle come into contact with any obstacle when the engine starts.

HT2310 / CHT2310
WARNING
Never place the throttle into the
high-speed position when starting
the engine.	G
3. After starting the engine, check	B
to make sure that the cutting at-
tachment stops moving when the
throttle is moved fully back to its
original position. If it continues to
move even after the throttle has
been moved fully back, turn off
the engine and take the unit to
your authorized ZENOAH servic-
ing dealer for repair.

USING THE PRODUCT

IMPORTANT

Cut only materials recommended by the manufacturer. And use only for tasks explained in the manual.

1. Grip the handles firmly with both

hands using your whole hand.

Place your feet slightly apart (slightly further apart than the width of your shoulders) so that

your weight is distributed evenly

across both legs, and always be

sure to maintain a steady, even

posture while working.

2. Keep cutting attachment below

waist level.

3. Maintain the speed of the engine at the level required to perform cutting work, and never raise the speed of the engine above the level necessary.

4. If the unit starts to shake or vi-

brate, turn off the engine and

check the whole unit. Do not use

it until the trouble has been prop- erly corrected.

5.Keep all parts of your body away from moving cutting attachment and hot surfaces.

6.Never touch the muffler, spark

plug, or other metallic parts of the engine while the engine is in op- eration or immediately after shut- ting down the engine. Doing so could result in serious burns or electrical shock.

GB-7